Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

2012 Honda civic valet switch not working.

0 votes
I installed Evo-One on honda civic 2012 with t-harness. Programming seems to have gone fine install seemed easy enough. Then I go to test the 3XLock to start and nothing happens, after checking settings and making sure harness wasn't damaged I decided to reset the unit and try again. When I turn on the car the valet switch does not enter unit into programming mode. I tried holding it for 10 seconds, I tried pushing it three times and nothing works. What could be wrong that would stop the Valet switch and remote start from working?
asked Jan 5, 2018 in Honda by Patrick Harper (130 points)

1 Answer

0 votes
The valet switch is the one connected with a wire to the module, NOT the button on the side of the module. Make sure you are pressing the correct one.

When turning ignition on yellow light turn on ?
answered Jan 8, 2018 by Mathieu Bertrand Collin (50,010 points)
Yup, I can read too, anyone have some helpful advice?