Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

sentra nismo 2017 pushstart shutdown after 3 sec

0 votes
Nissan sentra nismo pts 2017 programmed fine, manual sequence also works fine.  Probem is when remote started car shutsdownn 3sec after cranking.  Checked data with testone, brake tach and door trigger is fine...but i notice that handbrake light(on testone) shuts off a fraction of a second 3 sec after started.  tried firmware 72.29 also tried 72.28.  if i put the remote starter in automatic it always works fine ( but handbrake light also shuts off but starter does not mind in automatic if handbrake is on or off)so that is way i think its either handbrake or door input in data that is lost.  any info on this? oh yes im using Thar niss1.  I also have the 12v and gnd on the evo-one remote side connected( big harness 6pin plug)
asked Dec 30, 2017 in Nissan by yannick polasek (1,920 points)

2 Answers

0 votes
This issue is already under investigation. At this time the only solution would be to turn off the handbrake status in the flashlink manager and physically connect the handbrake wire to the vehicle.
answered Jan 2, 2018 by Mathieu Bertrand Collin (60,670 points)
Hi Mathieu thanks for the anwser...that is what i figured...do you know where i can get the handbrake signal other the going directly in the console.
0 votes
Problem fixed Need to put FIRMWARE 72.23. thanks
answered Jan 8, 2018 by yannick polasek (1,920 points)
...