Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

2011 Jetta Diode Installation

0 votes
I am installing an Evo-All with a T-Harness and a bypass transponder in a 2011 VW Jetta with a standard key.  The directions are stating to install a diode if the vehicle requires push brake to start.  My vehicle does require this feature and I am trying tio understand how the diode is wired.  The T-Harness directions are the only directions that show a diode in this circuit.  Is the diode wired in series of the D2 wire (yellow/blue) at the Evo-all and the T-Harness?  Is the T-Harness bypassed on this circuit and the diode is installed in series directly from the D2 wire (yellow/blue) to the BCM B3 (Black/Red)?

Your help will be greatly appreciated.
asked Dec 26, 2017 in Volkswagen by Robert Paganini (250 points)

1 Answer

0 votes
Cut the yellow/blue in the t-harness. The wire on the red connector side connect to two diodes anode side. One cathode goes to the yellow/blue on the t-harness side and the other cathode goes to the vehicle brake wire.
answered Dec 27, 2017 by Mathieu Bertrand Collin (49,470 points)
Thank you for the quick and concise reply.
...