Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

Juke will not 3x or RF start start without the OEM key in the car.. plus a few other problems

0 votes
EVO ALL THAR-NIS1 with RF kit FTX64-2W installed in a 2015 Nissan Juke PTS.

Easy install but had a heack of a time with the flashlink. Repeatedly told me that the device was disconnected when I would select save. Updated to the latest verion and went with the bare minimum selections only selecting what was shown in the manual.. D1 C1 H2. I know that theres more to be selected but seemed that when I would select what made sense.. it didn't like it and would disconnect when saved. So as of right now it is loaded with those basic commands. The module programming itself went smooth and ended with the slow blue pulse.. went through steps twice.

I failed to include the service number last week.. same question but sn is now included.

So with basic commands loaded I placed it back into the car and introduced the RF transmitters and moved on to the final steps... testing. I found that the car will not remote start with the oem fob or the RF fob unless the oem fob is in the car. Also, the rf fobs will not remote lock/unlock but does flash the lights.. can't remember if oem fob was in car or not? I did connect the lock/unlock wiring which was somewhat confusing by the diaagram.. it specifies in the instructions that 12 is blue and red is 13 but if you look at the pictures you have listed, its not that at all... If you count out the pins you'll see what I mean. I went by the picture..

Lastly, it was time to call it a day and button the car up and reschedule and I noticed that the parking lights were on. I can't recall but I believe it was while the car was locked but not 100% certain. The only way to get the lights to go away was by unplugging the module..

We're going to have another shot at this later today and any help is greatly appreciated.
asked Jan 2, 2017 in Nissan by Dan Archer (260 points)

2 Answers

0 votes
I am having the same issue!  Programming went fine and the vehicle starts but only if the key is next to the vehicle.  Also customer stated lights stayed on after leaving the shop and the traction control light was on and would not turn off.  I called tech support and they said check the blue and blue/black wires from the 20 pin but everything seemed to be fine.
answered Jan 2, 2017 by Karl Kuhn (320 points)
0 votes
Double check the ground wire in the T harness. I have had a couple where the crimp is loose where the wires come together. They do some strange things when that happens.
answered Jan 4, 2017 by Mike Evans (1,960 points)
...