Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

Can you help eliminate confusion hooking up Evo-All to UltraStart U1272-Pro

0 votes
After looking at the wiring diagram here for a 2009 Kia Sedona and comparing this to the hookup guide available from Fortin website I am confused as to which wires need to be hooked into the car on the Evo-All and which wires need to be hooked directly to the remote start module.

If I have this correct I THINK the Evo-All should hook to the Can-Bus and Can-Bus2, the ignition, and a Red data wire located near the ignition. Then the data-link wire should hook to the UltraStart module.

What I cannot figure out is what parts of the system will NOT be activated/controlled by the Evo-All module and will have to be wired from the UltraStart nodule directly.
asked Dec 26, 2013 in Kia by Stephen Alderink (130 points)

1 Answer

0 votes
Look at the beginning of the guide, it tells you what functions the EVO ALL covers by model year. What is not listed you will need to hard wire directly to your remote starter.
answered Dec 27, 2013 by Stephen Alderink (8,290 points)