Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

Flash Link options A1-A11

+1 vote
I'm setting up my evo-all with NIS1 T-harness as a stand alone remote starter in my 2009 infiniti fx35.

In the guide it says to turn on C1 nad D1, and that inturn enables D1.6 and thats all fine. But am I supposed to have everything else turned off? What about A1-A11, these were all turned on before so I left them on.

What about D2? Would the guide specifically say I need to set this?

 

One more thing, I might add a smartstart module later, should I turn on this now in the firmware or should I wait?
asked Mar 26, 2016 in Infiniti by Jason Seidel (280 points)

1 Answer

0 votes
 
Best answer
Leave all the A options On.

Enable D1 and C1.

D2 only needs to be on if you have a factory alarm or else the alarm will ring upon remote start.

Since you're already there, might as well enable the option for SmartStart. Really up to you.
answered Mar 26, 2016 by Robb (234,230 points)
selected Mar 26, 2016 by Jason Seidel
Thanks, this is exactly what I needed to know.
I believe D2 should be enabled, since all FX35 from my knowledge have a build in alarm. But I'm not 100% on that. I'm going to try it without first.

 

Do i need to enable D6, push to start as well?
Glad it helped!

As for D6. It would actually function with or without option D6 enabled on this vehicle.
Great, thanks a ton.
Everything working perfectly now, thanks to the help of you and the support guy I called. Apparently its not uncommon, but the labeling on my T-Harnes was wrong. RL1 and RL2 labels were swapped. Once I plugged in the one labeled RL2, it worked perfectly.

So I had to bust out the black sharpie and change the labels.

 

Thanks all.
...