Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

2013 Dodge Ram

0 votes
2013 dodge ram tip start

 

I'm using the "glacier start" remote starter kit from Grand West Enterprises.  It said I needed to connect the yellow ignition wire to the ignition source at the brake controller harness.  I tested it and it does get power on ignition.  I don't know what else to try.
related to an answer for: can bus program stays blue
closed as a duplicate of: Programming EVO-ALL
asked Nov 4, 2013 in Dodge by Ken Making (310 points)
closed Nov 4, 2013 by Robb

1 Answer

+1 vote
 
Best answer

In this programming procedure, there are a few steps to follow and a minimum required firmware.

 
What is the 12-digit service number written on the back of the EVO?

Are you using a T-Harness (THAR-CHR3 or THAR-CHR6)?

 

Note: reply by using the comment button below

answered Nov 4, 2013 by Robb (262,210 points)
selected Nov 19, 2013 by Robb
Service Number
Really, the only reason it normally stays on Solid is because it does not see ignition On. If the Can-Bus was at fault, then the LED would shut off and stay off.

I'd recommend disconnecting the 20-Pin white connector from the EVO-ALL, and with a multi-meter, test the voltage on the Yellow wire.
...