Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

cannot program evo-one on flashlink2(bypass)

0 votes
each time i plug  evo-one on the flashlink udater 2, unit automatcly disconnects after a few seconds.   in remote start mode its ok( i can flash it ) but in bypass mode i cannot doe anything.  tried another module on my flashlink and it goes fine.  Is the evoall part of the evoone defective ?
asked Dec 20, 2014 in Bypass by yannick polasek (1,920 points)

1 Answer

0 votes
Make sure the unit is actually disconnected when swapping from remote starter mode to bypass.
answered Dec 22, 2014 by Robb (245,310 points)