Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

2019 Mazda 6 not starting after successful programming with evo all

0 votes
Hey everyone,

I'm trying to install an EVO-ALL in standalone mode on a 2019 Mazda 6 with a T-Harness.

I initially successfully programmed the module with the two keys, and then successfully completed the CAN procedure as well. Unfortunately I could not get it to start, the module would have the red and orange lights on but would make no effort to crank the car.

I tried starting over by resetting the module, and now whenever I repeat the programming process I see a flashing red light, which supposedly means that the keys are already linked to the unit. Doing the CAN procedure now also results in all 3 lights cycling instead of the single blue light going off. Simply plugging the module in results in all 3 lights flashing.

I'm not entirely sure where to go from here. I'd like to start over but I'm not sure how to do that.
asked Oct 11, 2022 in Mazda by Saaif Khan (550 points)

1 Answer

0 votes
Please provide the S/N number on the back of the evo.

 

With the 2 key programming method you have followed you cannot simply "reset and start over", that was why it was flashing red.

 

If you proceeded to try and reprogrm just can-bus you have then put the evo into an entirly different programming mode.
answered Oct 11, 2022 by derek ! (284,570 points)
I appreciate the help Derek! My apologies, I didn't realize I put it into another programming mode. Please let me know what I need to do to return to the previous mode.

The S/N for this EVO-ALL is 001A07160916.
master reset the evo: https://cdn.fortin.ca/en/download/61931/61931.pdf

 

Once that is done plug it into a computer and run dcryptor, let me know if dcryptor passes.
Thanks again Derek, I will give it a shot and let you know when I get a chance to work on the car
I reset the unit and ran decryptor but recieved a message saying "The immobilizer data received from the module is incomplete". I tried to reset once again but the same occurs.

I also noticed that if I try to turn off "Prevent options reset from a master reset" and click "save options" it does not actually stick. It seems to force this setting to ON.

Please let me know what I can do next
The next step will require you get a different evo-all and program it to the vehicle.

 

I suggest calling into technical support once you get a new evo so we can walk you through it to avoid this happening a 2nd time.

 

1-877-336-7797
...