Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

Ford Focus 2017 No flashing blue light on initial step to program

0 votes
I was sent an EVO all that was preprogrammed.  During first attempt, something went wrong, and I think by whole unit had the programming erased.  I bought my own Flash Link updater, and loaded the settings based on standard questions.  I believe I have everything right, but when I take the module to the car and hold down the program button and plug in the data cable, I only get the solid red light.  No alternating blue, yellow, red. I did get them on my first attempt, but not after my reprogram.

 

Can anyone help?
asked Jun 17 in Ford by Bill Hagerty (180 points)

1 Answer

0 votes
 
Best answer
Follows this link to correct the solid red led issue: https://www.wirecolor.com/en/qa/92073/faq-red-led-stuck-on?show=92073#q92073
answered Jun 18 by Derek (223,850 points)
selected Jun 18 by Bill Hagerty
this helped me. I did have an additional problem, at the end I had both blue and red flash 10x at the same time, so I thought I did something wrong, because my dash said No Key Detected.  So a couple times I restarted too early, when I found out I should let it go a few more seconds to finish the programming.  It worked, when the car started and turned off by itself.

 

Thank you so much for your comment and reply.  Good day Derek!
...