Quick Vehicle Finder
Find the right solution for your vehicle

EVO-ONE Status

EVO-ONE Status

Service No: 002B07144688

Preload date: 44-2016

Hardware version: 7

Firmware version: 1.24

RS232 protocol: FORTIN

Vehicle: Hyundai Accent 2016 - Standard-Key

EVO-ONE Options

2.PROGRAMMABLE OUTPUT (+) IGN/ACC/START
Configure the main harness output.
2.1
White: (+) Ignition2, Orange: (+) Accessory, Pink: (+) Ignition, Yellow: (+) Start.
2.2
White: (+) Accessory2, Orange: (+) Accessory, Pink: (+) Ignition, Yellow: (+) Start.
2.3
White: (+) Start2, Orange: (+) Accessory, Pink: (+) Ignition, Yellow: (+) Start.
2.4
White: (+) Start, Orange: (+) Ignition2, Pink: (+) Ignition, Yellow: (+) Start2.
3. TACHLESS SENSIVITY
Configure the sentivity of the tachless detection.
3
2
1
-1
-2
-3
Increase / Decrease crank time.
4. REMOTE CAR STARTER RUNTIME
Configure the required remote start runtime.
4.1
Gas: 15 minutes Diesel: 30 minutes
4.2
Gas: 7 minutes Diesel: 14 minutes
4.3
Gas: 3 minutes Diesel: 6 minutes
6. DOOR LOCK BEFORE AND AFTER REMOTE-START
Configure doorlock behavior before and after start.
6.1
NO
6.2
Unlock before remote-start & Lock after remote-start.
6.3
Lock after remote-start.
OFF
6.4
Unlock and relock after shut-down.
OFF
6.5
Relock 10 sec. after shut-down.
OFF
6.6
Disarm Before ShutDown
7. IGNITION DOORLOCK
Configure automatic lock in movement.
7.1
NONE
7.2
Lock after foot-brake & unlock after key is turned off.
7.3
Unlock after key is turned off.
OFF
7.4
Doorlock Output at Ignition only.
8. UNLOCK PULSE TIME
Configure the behavior of the unlock wire.
8.1
Single 0.25 sec pulse.
8.2
Double 0.25 sec pulse.
8.3
Single 4.0 sec pulse.
8.4
Single 2.5 sec pulse.
8.5
Single 1.5 sec pulse.
8.6
Single 0.75 sec pulse.
9. ACTIVE OR PASSIVE STARTER KILL
Configure the automatic arming of the alarm.
9.1
Active. Press LOCK to activate the Alarm and starter-kill.
9.2
Passive (Lock disabled). O14M1: Activate starter-kill X seconds after the ignition is Turn OFF. O14M2: Arm alarm activate starter-kill X seconds after the door is closed.
9.3
Passive (Lock enable). O14M1: Activate starter-kill X seconds after the ignition is Turn OFF. O14M2: Arm alarm activate starter-kill X seconds after the door is closed.
9.4
Passive arm 30 seconds (by default if MODE 2 ot 3 is activated)
9.5
Passive arm 60 seconds. (if MODE 2 ot 3 is activated)
9.6
Passive arm 120 seconds. (if MODE 2 ot 3 is activated)
10. STARTER KILL OUTPUT
Configure the starter kill output.
10.1
Starter-kill & anti-grind
10.2
Anti-grind only
10.3
Relay normally open
11. CONFIRMATION SOUND AND ANTENNA LED
Configure the audible confirmation and antenna LED.
11.1
Silent on 1st LOCK/UNLOCK press. Sound on 2nd LOCK/UNLOCK press. Antenna LED active.
11.2
LOCK/UNLOCK sound always.
OFF
11.3
Antenna LED disabled.
OFF
11.4
Antenna LED disabled with ignition.
OFF
11.5
Horn lock only.
OFF
11.6
Panic Disable
12. OUTPUT HORN/SIREN
Configure the horn and siren output.
12.1
Horn Only. Output programmed to be used for vehicle horn.
12.2
Siren (+). 5th relay require.
12.3
Siren(+) Output (E1) white and Horn(-)
12.4
Siren(-) only (A7)
13. CONFIRMATION PULSE
Configure the pulse lenght of the horn output.
13.1
Long
13.2
Short
13.3
No Horn & Siren
14. ALARM ON/OFF STARTER ON/OFF
Activate or desactivate the remote starter and alarm.
14.1
Alarm disabled. Remote-starter enabled.
14.2
Alarm enabled, Remote-starter enabled.
14.3
Alarm enabled. Remote-starter disabled.
15. SMART DOOR LOCK
Automatic relock and arming.
15.1
Disable
15.2
(Unlock signal) Automatically LOCK and rearm alarm if door(s) are not opened after 30 seconds.
OFF
15.4
Arm pulse only when the alarm is disarmed.
16. COLD START TIMER
Starter the vehicle periodically when temperature is below -5C
16.1
3 hours at 5 Celsius / Runtime (Option 4).
16.2
1.5 hours at 5 Celsius / Runtime (Option 4).
16.3
3 hours at 5 Celsius / 5 minutes.
16.4
1.5 hours at 5 Celsius / 5 minutes.
16.5
Cold time OFF
18. DIESEL MODE
Enable diesel mode
18.1
Disable
18.2
Enable (20 seconds) Delay between Ignition power up and Starter (crank).
18.3
Enable (10 seconds) Delay between Ignition power up and Starter (crank).
18.4
Enable. No delay between Ignition power up and Starter (crank).
19. TURBO MODE
Car will remain running for a period of time when engaged.
19.1
Disable
19.2
Run 2 minutes.
19.3
Run 4 minutes.
20. ENGINE SUPERVISION
Configure tachometer.
20.1
Tachless on crank and supervision by Tach Data-Link
20.2
Tachless only.
20.4
Start (crank) 8 seconds on Tachless.
20.5
Start (Crank) 8 sec + Supervision by Data-Link Tach.
20.6
Tach Data-Link only.
21. START ATTEMPTS
Configure the amount of try to remote start.
21.1
2 times.
21.2
1 time.
21.3
3 times.
24. Special Applications
See vehicle installation guide for Option 24.
24.1
Disable
OFF
24.2
No Power output Relay in Idle Mode
OFF
24.3
GND Output in Idle Mode Only
OFF
25. YELLOW/BLACK (A13) : AUX1
Configure the yellow/black output.
25.1
0.5 seconds, Disarm EVO-ONE alarm, if option is enable (O14M2)
25.2
0.5 seconds, Do not disarm EVO-ONE alarm if option is enable (O14M2)
25.3
10 sec latch or until a button is pressed.
25.4
20 sec latch or until a button is pressed.
25.5
30 sec latch or until a button is pressed.
25.6
When activated, Latch until RS shutdown.
26. HYBRID MODE
See your specific installation guide.
26.1
Gas / Diesel vehicle.
26.2
See your specific installation guide.
29. ALARM DURATION
Configure the duration of the alarm when triggered.
29.1
30 seconds.
29.2
60 seconds.
29.3
120 seconds.
30. VALET CODE
Configure the valet procedure.
30.1
Ignition ON + 3x valet button
30.2
Ignition ON + 3x valet button + 1x for 3 seconds
30.3
Ignition ON + 4x valet button + 1x for 3 seconds
30.4
Ignition ON + 5x valet button + 1x for 3 seconds.
30.5
Ignition ON + 6x valet button + 1x for 3 seconds.
30.6
Ignition ON + 7x valet button + 1x for 3 seconds.
31. SPECIAL APPLICATION PROGRAMMABLE OUTPUT (+)
Configure the main harness. Priority to option 2.
31.1
Disable
31.2
Enable at ground out. Disable with ignition off. Special application - Function 2 (all options) will not be available.
31.3
White wire: (+) Trunk Ouput Special application - Function 2 (all options) will not be available.
31.4
WHITE: (+) Parking Lights, ORANGE: (+) Accessory, PINK: (+) Ignition, YELLOW: (+) Starter
31.5
WHITE: (+) Parking Lights, ORANGE: (+) Ignition2, PINK: (+) Ignition1, YELLOW: (+) Start
31.6
WHITE: (+) Parking Lights, ORANGE: (+) Parking Lights, PINK: (+) Ignition1, YELLOW: (+) Start
32. GROUND OUT
Configure the behavior of the Ground out output (A8).
32.1
Shut-down 1s after remote start run time. Dark Blue wire (ground out)
32.2
Shut-down 3s after remote start run time. Dark Blue wire (ground out)
32.3
Shutdown after start. Dark Blue wire (ground out)
32.4
Starter-Kill. Dark Blue wire (ground out)
32.5
Arm/Rearm. Dark Blue wire (ground out)
32.6
Bypass Control (ground out)
33. MANUAL TRANSMISSION READY MODE ACTIVATION
Configure ready mode for manual transmission.
33.1
Activated by remote starter remote. Ready mode activated with the starters remote.
33.2
Automatically activated by hand-brake and Foot Brake (ON). Not functionnal on tachless. Tach must be connected.
OFF
33.3
Shutdown when lock with remote.
OFF
33.4
Hatch Detection Enable
34. TRUNK OUTPUT (OPTION 25 WILL BE DISABLE)
Configure the trunk output.
34.1
Pulse 0.5 seconds.
34.2
Pulse 2.5 seconds.
OFF
34.3
Unlock before trunk
OFF
34.4
Trunk Output When Remote Started only.
35. DOOR UNLOCK SPECIAL APPLICATION
Configure ignition with unlock.
35.1
Disable
35.2
Activate vehicle ignition at unlock.
35.3
Activate vehicle ignition and accessory at unlock.
36. ACTIVATION/DESACTIVATION REMOTE VALET MODE
Configure the activation of the valet mode.
36.2
By remote : AUX --> Lock + Unlock or valet button.
36.3
By Valet button only.
37. SECURITY REMOTE CAR STARTER SPECIAL APPLICATION
Shut down remote starter when a door is open without unlock.
37.1
Disable
37.2
Security ON: Shutdown Engine if the door is opened before UNLOCK is pressed. Door trigger required.
38. SYSTEM CONTROL BY OEM REMOTE
Configure control by OEM remote.
38.1
Disable
38.2
Enable (Press 3x Lock to remote start) (Bypass module required).
OFF
38.3
Trigged to Start
38.4
Enable Control by OEM Remote.
38.5
Enable: Press Lock-Unlock-Lock to remote start. (Bypass module required).
39. TEMPERATURE OPTION
Activation of AUX1 depending on temperature.
39.1
Disable
39.2
Enable : AUX1 activated at +5 Celsius when remote started (see function 25).

Wirecolor.com

the ultimate online tool

Visit wirecolor.com for wiring information and photographs providing detailed installation processes.

Email Sign Up

Get products & corporate
updates with our newsletter.