Fortin Evo-one help
So I installed the Fortin Evo-one today and I can't get it to do anything. I have checked my wiring 3 times to ensure I have it correct and it looks good. I get through the bypass programming procedure successfully but it won't do anything. I see the blue light on the unit flash when I hit the lock/unlock button. When I press my oem remote lock 3 times it just does what it did before I had the evo installed (beep and parking lights with each press).
I think I have it programmed correctly but could use some help. Could it be that I have the OEM alarm with shock sensor installed? Is there a setting I need to change for that?
Here is what I have set:
Bypass firmware 79.31- below are things that are on
A3- Key Bypass
A5- Aux 1 can't turn this off I get an error that the unit doesn't support this
A6- Aux 2 can't turn this off I get an error that the unit doesn't support this
A8- Hand-Brake (output status) can't turn this off I get an error that the unit doesn't support this
C1- OEM Remote Monitoring
Remote-starter firmware 1.16
2.4
3 tachless sensitivity: 1
4.1 (runtime)
6.2 unlock before remote start and lock after remote start
7.1 Safety locks: none
8.2 Unlock pulse time: double 0.25 sec pulse
9.1 Active or passive starter kill: Active starter kill. press lock to activate the alarm and starter kill
11.2 Confirmation: lock/unlock sound always
12.1 Sound confirmation: horn only. output programmed to be used for vehicle horn
13.2 Pulse confirmation: short
14.2 Alarm and Starter options: Alarm enabled, remote starter enabled.
15.1 Smart door lock: disabled
16.5 Cold start timer: off
18.1 disable disel mode
19.1 disable turbo mode
20.6 Tach data-link only
21.1 start attempts 2 times
24.1 Special applications disable
25 Off
26.1 gas/diesel vehicle
29.1 Alarm duration 30 sec
30.1 Valet Code: Ignition ON + 3x valt button
31.1 Special application programmable output: Disable
32.1 Ground out: Shut down 1s after remote start run time. Dark Blue wire (ground out)
33.1 Manual transmission ready mode activation: Activated by remote starter remote. Ready mode activated with the starters remote
34.1 Trunk output: Pulse 0.5 seconds
35.1 Door lock special application: Disable
36.3 Activation/Deactivation remote Valet mode: By valet button only
37.1 Security remote car starter special application: Disable
38.2 System control by OEM remote: Enable (press 3x lock to remote start (bypass module required)
39.1 Temperature control: Disable
I also noticed I can't get programming to work with the valet button. It won't do anything.
I have a 2016 Toyota Tundra TRD Pro and I used the evo-one with Ttoy2 harness. Truck has the OEM remote with shock sensor.
-Ruben
0
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
