This is 2013 Toyota Camry G Key. Bypass Version 79.37 and Remote Starter version 1.19.
Bypass version a1 to a11 is on. Rest all are off.
When i try to start the car using Remote, Vehicle crank but wont start. Parking light flashes 4 times. This means Tach signal is not obtained properly from Can bus.
I see sometimes, car Starts and since Tach signal is not obtained properly the starter disengages slowly.
Sometimes it crank and it wont start. Please advise how to solve the problem. I am using fortin RF642W
remote and the remote are configured with no issues.
I have verified Can high, Can Low and IMMO data from where i tapped to the wiring harness of EVo one, i see good continuity.
Issue 2: My OEM remote is not working. I enabled 3 times lock on remote and bypass but still not working. Not a major issue. but dont know why it is not working. PLEASE NOTE i have enabled 3xlock on remote start and oem remote monitoring on bypass, but still it doesnt work.
Issue 3: After i remote start the car(when it work sometime) if i open the door(getting my hand inside the door and opening the door from inside), there is no alarm. I am thinking that if i lock the car with remote, and when car is remote started, then if i try to open from inside of the car, i expect car alarm to come on but notihing happend. Issue 2 and 3 are not high priority. but for sure issue 1 have to be addressed. I am happy to wire tach (hard wire). but dont know what to connect from where..
i have cross verified my
here is my option for remote starter version 1.19.
39.1
38.1
37.1
36.2
35.1
33.1
34.1
32.1
31.1
30.1
29.1
26.1
25
24.1
21.1
20.6
19.1
18.1
16.5
15.1
14.1
13.2
12.1
11.1
11.4
11.3 off
9.1
4.1
6.1
7.1
8.1
2.4
1
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
