Is there a problem with guide (34911 Rev. 2060914, 2014 Kuga PTS ATM, evo-all FW 71.35 and 71.44) or am I doing something wrong?
Problems begin from step 6:
6. Press and release the Push-to-Start button to turn ON the ignition.
The YELLOW LED will turn on.The RED LED will turn OFF.
> In my case yellow led turns on but red doesn't turns off by itself. It turns off only when I tap the brake pedal.
7. Press and release the Push-to-Start button once to shut off the ignition.
99The YELLOW LED will turn OFF. The RED LED will turn on.
> This time everythings ok
8. Press and release the Push-to-Start button to turn ON the ignition.
The YELLOW LED will turn on and off.The RED LED will turn OFF. WAIT, the BLUE LED to flash rapidly.
> Now red doesn't turns off and no yellow (waited 1 minute). Then I tapped brake again and red goes off, yellow blinked one time and after that blue flashes rapidly.
9. Is ok - red and yellow alternates.
Is it possible that this additional brake tapping causes key to read abnormally? Because after all this actions Decrytor worked without errors but after trying to remote start I see "Key doesn't recognized" and car can remote starts only when I place FOB near driver's window.
P.S. One more problem with wires in guide is that A17 & A18 are swapped. If I connect them by guide - car can't lock doors because it "thinks" that door doesn't closed firmly.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
