Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

EVO ONE Installation/Programming 2004 Ford Expedition

I have installed the Evo-One module and the wiring as follows: (Guide #22301) A1 of 20 pin harness (yellow) to E5 of 6 pin harness (pink) A10 of 20 pin harness (ight blue/black stripe) to RX (Pin 4) of igntion barrel connector C (gray/orange stripe) A11 of 20 pin harness (black) to Green wire for foot brake connector (above foot brake) A20 of 20 pin harness (light blue) to TX (Pin 3) of ignition barrel connector C (white/green stripe) E1 of 6 pin harness (white) to Brown wire of light selector switch E2 of 6 pin harness (orange) to accesory wire of ignition switch (black/light green stripe) E3 of 6 pin harness (red) to constant battery power of igntion switch (light green/violet stripe) E4 of 6 pin harness (black) to ground E5 of 6 pin harness (pink) to A1 of 20 pin harness and ignition wire of the ignition switch (dark blue/light green stripe) E6 of 6 pin harness (yellow) to starter wire of ignition switch (red/light blue stripe) When I go to program it, I get to the final step and the red doesnt flash ten times like its supposed to. I get to the red light, turn the ignition to RUN, then the lights show red and yellow. I wait three seconds then turn it to off, which goes back to a solid red. I pull the key out of the ignition, then reinsert and turn it back to RUN and the red light flashes once then stays solid red. I turn the key to off and pull it out of the ignition and the light stays a solid red. The firmware for the bypass is 4.18 which is recommended by the Flashlink Manager, but the install guide #22301 recommends 71.35. Could that be the problem? The remote start recommended firmware is 1.24. Could I have gotten the RX and TX wires not hooked up correctly? Do I need to run the Dcryptor? I ran the dcryptor as the intstructions said and it seemed to have worked. I'm not sure what I would need it for. Do I need to use the valet switch? If I want to install a hood pin, which wire do I connect it to of the 20 pin harness? If you could help me out I'd greatly appreciate it. Thanks.

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer