EVO-ALL Status
EVO-ALL Status
Service No: 001A07186362
Preload date: 45-2020
Hardware version: 7
Firmware version: 63.05
Recommended version: 74.38
RS232 protocol: FORTIN
Vehicle: Jeep Wrangler 2020 - Push-to-Start
Dcryptor:DCryptor has finished processing the data. The module has been updated and it is ready for use.
EVO-ALL Options
|
OFF
ON
|
*** Settings protection Prevent options reset from a Master Reset.. |
|
OFF
ON
|
A1 - Door locks Door lock & unlock control. |
|
OFF
ON
|
A2 - Trunk Release Trunk / hatch release. |
|
OFF
ON
|
A3 - Key Bypass Immobilizer bypass. |
|
OFF
ON
|
A4 - Heated seats Automatic low temperature heated seats & rear-defrost control. |
|
OFF
ON
|
A5 - Aux. 1 Vehicle specific function. (e.g. Right Sliding Door, Power Lift Gate). |
|
OFF
ON
|
A6 - Aux. 2 Vehicle specific function. (e.g. Left Sliding Door, Gas Cap Release). |
|
OFF
ON
|
A7 - Foot-Brake (output status) Foot-brake output. |
|
OFF
ON
|
A8 - Hand-Brake (output status) Hand-brake output. |
|
OFF
ON
|
A9 - Door Trigger (output status) Door trigger output. |
|
OFF
ON
|
A10 - Trunk Trigger (output status) Trunk / hatch trigger output. |
|
OFF
ON
|
A11 - Hood Trigger (output status) Hood trigger output. |
|
OFF
ON
|
A12 - Unlock before trunk release |
|
OFF
ON
|
A13 - Ignition lock |
|
OFF
ON
|
A14 - Parking light control |
|
OFF
ON
|
B1 - Unlock Driver Door Only Simulate the OEM key-fob with driver's door priority unlock on 1st unlock signal. All doors unlock on 2nd unlock signal. |
|
OFF
ON
|
B2 - Data-Link Remote Starter Mode Switch input/output mode to support external RF antenna. |
|
OFF
ON
|
B3. Unlock double pulses |
|
OFF
ON
|
C1 - OEM Remote Monitoring Send OEM remote lock & unlock commands to the remote car starter or alarm system via data-link. |
|
OFF
ON
|
D1 - Standalone Remote Starter Remote start the vehicle when the OEM remote's lock button is pressed 3x times. An aftermarket remote car starter is NOT required. |
|
OFF
ON
|
D1.1 - Lock-Unlock-Lock |
|
OFF
ON
|
D1.2 - Disable 2nd start attempt |
|
OFF
ON
|
D1.3 - Diesel mode |
|
OFF
ON
|
D1.4 - 3 minute runtime Diesel mode 6 minute runtime |
|
OFF
ON
|
D1.5 - 7 minute runtime Diesel mode 14 minute runtime |
|
OFF
ON
|
D1.6 - 15 minute runtime Diesel mode 30 minute runtime |
|
OFF
ON
|
D1.7 - 20 minute runtime |
|
OFF
ON
|
D1.8 - 30 minute runtime |
|
OFF
ON
|
D1.9 - 60 minute runtime |
|
OFF
ON
|
D1.10 - Lock-Lock-Lock |
|
OFF
ON
|
D1.11 - Crank 20s |
|
OFF
ON
|
D2 - Unlock before/Lock after (Disarm OEM alarm) Automatically unlock & disarm before remote-start and re-lock & re-arm after remote-start. |
|
OFF
ON
|
D3 - Door Open Shutdown Remote-starter shuts down the engine when a door is opened. |
|
OFF
ON
|
D4 - Hybrid Mode |
|
OFF
ON
|
D5 - Lock after start Lock the doors after remote start. |
|
OFF
ON
|
D6 - Push-To-Start |
|
OFF
ON
|
D7 - RAP Disable |
|
Special Functions |
|
OFF
ON
|
E1 - GPS I/O Reconfigure the I/O to control selected GPS unit. |
|
OFF
ON
|
E2 - Run status |
|
OFF
ON
|
E3 - ODB Info |
|
OFF
ON
|
E4 - Feature 1 |
|
OFF
ON
|
E5 - Feature 2 |
|
OFF
ON
|
E6 - Feature 3 |
|
OFF
ON
|
E7 - Feature 4 |
|
OFF
ON
|
E8 - Feature 5 |
|
Datalink protocols |
|
OFF
ON
|
F1 - Fortin Fortin RS-232 Datalink Procotol. |
|
OFF
ON
|
F2 - AP/OFA Datalink AP Datalink, OFA Datalink. |
|
OFF
ON
|
F3 - D2D |
|
OFF
ON
|
G - Evo Alarm System Compatible with OEM remotes and RF kit antenna. |
|
OFF
ON
|
G1 - Confirmation On = Horn. Off = Siren. |
|
OFF
ON
|
G2 - Chirp Confirmation Lock/Unlock chirp confirmation. |
|
OFF
ON
|
G3 - Silent First Lock/Unlock silent. |
|
OFF
ON
|
G4 - Smart Rearm Rearm the alarm system after disarm if no doors are opened for 30 seconds. |
|
OFF
ON
|
H - Supported RF kits |
|
OFF
ON
|
H1 - Fortin Fortin (AST, DSE, Atom, etc.) |
|
OFF
ON
|
H2 - Fortin 2 Fortin2 (FMH, EVO-START...) Autoconnect |
|
OFF
ON
|
H3 - CrimeStopper, Omega OL-RF |
|
OFF
ON
|
H4 - AudioVox FLRF |
|
OFF
ON
|
H5 - DEI XL202 |
|
OFF
ON
|
H6 - FT-D100 |
