I am installing an evo-all, tb-vw, and thar-vw3. Programming completes as well as the decryption. Vehicle will start and stall with a no key message displayed on the cluster. The evo-all rapidly flashes red when attempting to start, then goes solid red, and sometimes followed by an amber light. I have tried both the blue wire and brown wire on the transponder wiring. I have also swapped around the green wiring on the tb-vw with no change. Swapped the evo-all and the tb-vw out with a new one but it is still having this issue. Vehicle will start if key is in the ignition and the remote start sequence is started. The vehicle will also start normally with the key. I have 12v at the red wire on the tb-vw, and ground present on the black wire. Both data wires ohm out OK and the wires are in the correct spots according to the diagram. Wiring on the red connector had to be modified following the Jetta guide as this beetle requires the brake pedal to be pressed. I have also tried rolling back the firmware to 75.38 as this is the earliest according to the guides.
Original evo-all sn: 001A07-106465, TB-VW 2019
2nd evo-all sn:001A07-198285, TB-VW 11/20
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
