Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

08/03/2018

 Toyota Bezalel Hirsch (310Pts.)

0

Evo-One RF CRIMESTOPPER RFALL642W FM RF

For the Evo-one with CRIMESTOPPER RFALL642W FM RF which rf kit do i program it for?

Is the same as "Fortin FM"?

 

Also, can the evo-one be used with an rf kit and Compustar Drone (DR-3400)? What do I need to program for to work with Compustar Drone (DR-3400)?

 

Thanks

Login to reply View 1 answer(s)

30/01/2017

 Toyota bob mccall (130Pts.)

0

Will the EVO-ALL work without data link

I have a 2012 Toyota RAV4 it does not have data link. Will I be able to install the evo all as a remote starter?
Login to reply View 1 answer(s)

05/09/2016

 Toyota James G. (340Pts.)

1

Horn blowing constantly when Evo-All data link is disconnected

Installed an Evo-All + Prestige APS-57E system on a 2015 Corolla S. I also enabled the Evo-Alarm function. Everything works perfectly. But I accidently noticed what I believe could be a bad unit issue...

 

If I disconnect the datalink connector of the Evo-All, the horn constanly blows.

 

I even disconnected ALL connectors from the Evo-All and connected just the Evo-All by itself to the 20-pin harness and the horn started blowing again?? I have never seen this happen before and am worried that if the vehicles battery was ever disconnected, the client's horn would just start blowing? 

 

Somehow, the Evo-All has an internal ground signal inside itself? I tried reseting it as well. I also disconneted the horn connector from the steering wheel column and the Evo-All would still send a ground signal to the horn wire and blow it.

 

Conencting the data-link conector stops this from happening the the Evo works fine again. Is this just a bad unit?

Login to reply View 2 answer(s)

05/09/2016

 Toyota James G. (340Pts.)

1

Horn blowing constantly when Evo-All data link is disconnected

Installed an Evo-All + Prestige APS-57E system on a 2015 Corolla S. I also enabled the Evo-Alarm function. Everything works perfectly. But I accidently noticed what I believe could be a bad unit issue...

 

If I disconnect the datalink connector of the Evo-All, the horn constanly blows.

 

I even disconnected ALL connectors from the Evo-All and connected just the Evo-All by itself to the 20-pin harness and the horn started blowing again?? I have never seen this happen before and am worried that if the vehicles battery was ever disconnected, the client's horn would just start blowing? 

 

Somehow, the Evo-All has an internal ground signal inside itself? I tried reseting it as well. I also disconneted the horn connector from the steering wheel column and the Evo-All would still send a ground signal to the horn wire and blow it.

 

Conencting the data-link conector stops this from happening the the Evo works fine again. Is this just a bad unit?

Login to reply View 2 answer(s)

07/02/2014

 Toyota Nick Schaf (420Pts.)

1

2007 Toyota Tacoma & EVO-RIDE: Dinging when door is open, but no key

EVO-RIDE Service Number: 000903020460 As soon as power is applied to the EVO-RIDE (through the data link cable), the car begins dinging as if there is a key in the ignition. It continues to ding as long as the ignition is off and the door is open. The remote start works, but all warning lights in the instrument cluster remain on even after key take-over. Owner needs to press brake to release the remote-start, then re-start vehicle with the key to resolve the warning lights. Module came with formware version 2.03. Tried re-flashing to 0.17 as recommended by technical support since it is supposed to resolve the "Toyota Key Sense" problem. Both firmware versions exhibit the same behavior. Remote start system is Cromestopper Cool Start RS3-G4, connected to EVO-RIDE through data link.
Login to reply View 1 answer(s)

08/01/2014

 Toyota Ivan Serduk (220Pts.)

1

G-key and remote starters

Hi! Im sorry but, i got a problem. I have Toyota camry 2011 G-key and Evo-all, I live in Russia, and Russian Fortin specialist cant tell me about, have evo-all work with my car. So, can you give me answer? If i buy and install remote starter with Evo-all, it will be worked from my OEM key or not? Evo-all hardware - vr.6, firmware vr. 4.18. Remote starter what i want to buy is - Crimestopper RS4 G4 or RS1 G4 - it is datalink compability remote system?
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue