User

I installed the EVO ONE without T-Harness and RFK411 on a 2014 Scion XD (with standard key). Sometimes after remore start, when the door is opened the alarm is set off and the remote start is halted. Option D2 was inititially turned off.  I turned it on and though it improved quite a bit, it still happens every now and then.  The system is wired and configured per Guide # 102241.  Any help would be greatly appreciated.

Is it necessary to cut the 15 pin white connector that contains the red and black wires (power and ground) on the NIST4 harness for the 2016 Infiniti Q50 3.0 as shown on Guide #75841?

 Guide # 75841 

I undertand that if I wanted to use the Directed 7756V remote I will need to add the XL XL202 RF to Data converter to my EVO ALL.  My question is which antenna will I need to purchase in order for the 7756V remote to work.

2015 infiniti Q40 evo-all remote-start rf-kit push-to-start 

I am installin the RFK942 to my 2010 Acura TL.  Will there be any additional wires that will need to be connected at or to my EVO ONE (besides the cable from the antenna)?  Are there any features that need to be turned on on the Flashlink Updater and if so, where will they be found?  Thank you.

Firtsly, is there a solution for my Infiniti Q60 Red Sport (3.0T)?  Wouldn't the EVO All or EVO One with the T-Harness that works on the 2017 Q50 3.0 with Push-to Start work with my car?

If the answer to the question is yes, then here are a few more questions.

My Q60 has factory remote start.  The remote has the remote start button.  Would I use the remote start button or would I still have to press the lock button 3 times? Would I be able to add an RF Kit?

While installing the EVO One to my 2010 Acura TL (with Push-to-Start) I found that several of the wire colors called out by the installation (REV:20191022, Guide 19411) and the Wire Color guide did not match what the car has (on gray 32 pin connector and blue 36 pin connector).  I proceeded by connecting at the specified locations shown on the diagram.  Once the connections were completed, I attempted to program the module (which was updated and programmed with the Flash Link Updater).  Step 1-4 went OK, however, when I got to step 5 (Do not press the brake pedal.  Press the Push-to- Start button twice to turn on the ignition--  The RED LED will flash rapidly 10x times. -- Key bypass programmed. --The BLUE LED will flash rapidly. --CAN-Bus programmed.), the red LED extinguished and I could not complete the programming.  I tried this several time with the same results.  Your help with this issue will be greatly appreciated.