English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

17/12/2015

 Mitsubishi jetskiman98 (140Pts.)

1

2012 Outlander Sport PTS will not start after installation

I installed an Evo-One (AX-One) in my wife's 2012 Outlander Sport. After after all the wiring was complete, I went to program the unit as per the directions only to find that vehicle will not start. It will not turn on. The car will not acknowledge the Push-To-Start button. Pressing the button only a yields a red back light, there are no other chimes and the display doesn't light up. I reconnected the CAN wires that were cut and the vehicle powers up and starts fine. I went back over the wiring diagram, tried again, and still had no sucess. Is there something that I could be missing? Has anyone else heard of this issue?
Connectez-vous pour répondre Voir 1 réponse(s)

25/11/2015

 Mitsubishi Saul G. (130Pts.)

0

EVO-ONE Ready mode issue 2008 Mitsubishi Eclipse / AUX Output

I have an Evo-One installed on a 2008 Mitsubishi Eclipse, Manual Transmission. The car is equipped with the factory alarm. I have function 32.5 (Ground out - Arm/Rearm) enabled as the installation guide states. It is connected to the Lt. Green driver door pin wire. However, after I put the car in “ready mode” when the car shuts off after I close the driver door and the pulse gets sent to the door pin (to arm/rearm factory alarm) it disables my “ready mode” as well. When I figured that out, I disconnected the (-GWR) wire from the door pin wire and the remote start works perfectly. Only thing is now the factory alarm doesn't arm after shut down of the remote start. Is there anything I can do? Or should I just keep that wire disconnected since everything else works fine. Also, what wire do I use to connect an AUX output? I’d like to wire in my rear defrost to activate when I press Aux 1 on my remote.
Connectez-vous pour répondre Voir 1 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer