Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

evo all with rfk411 starts 2014 wrangler but immediately shuts off

i have the evo all, updated firmware, corrected the setytings in the flashlink to use H2 for the rfk411,what els eshould be enabled? the jeep starts, runs for 2 seconds and then iss witched off again by the evo all. then the evo has the red and orange light solid.

0

Where is the Tach wire on the EVO-ONE

2014 Wrangler manual transmission I have no remotes for this unit and plan on using the OEM remote. The unit will not remote start. The flash tool says that the tach wire needs to be hooked up, not to use the tachless mode. So, Which wire is it? I will need the PIN number too since the extra wires have been removed to reduce the wires in the install.

0

2014 jeep compass wont start push button 3x

will lock and unlock but wont start.

0

2014 Jeep Patriot Purpose of hood pin/valet, parking light, start/stop external connections

I am looking to Connect a Evo-All Stand Alone on a 2014 Jeep Patriot. I am following installation diagram C. When I bought this evo, it was preflashed and listed as only needing to connect the harnesses. I have not attempted any installation yet. For the single wire connection coming off the 20 pin connector, I am looking for more infomation on the purpose of them to determine what is necessary and to allow me to locate the wires and troubleshoot any incorrect connections. -For the 20 Pin Connector i. Externial input (Start/Stop External control negative) - What is this and what would this connect to? ii. Parking light out negative (this is the white/purple positive for 2014 jeep patriot) - Is this just to blink the break lights and would a relay be required to make this connection, if so is this connection necessary. If it is necessary would it connect to the red/purple wire (shown on wirecolor.com under parking lights) iii. Hood pin/Valet switch (no valet switch for 2014 Jeep Patriot which is a hatchback) is this a necessary connection and if so, where would this connect to near stearing column (without running under hood to actual switch). The directions state that this is optional, dark blue (from 20 pin connector) with no polarity given. Wirecolor.com list this as negative black/pink (from the 20 pin connector), and has no location or pictures of the colors. Yellow and Green/orange will be connected per instruction C. Seller Flashed for Stand Alone T Harness Hardware V6 Firmware Vr 74-19 (Seller may have updated it further) Date 11/2015

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer