I have a 07 toyota tundra. I am installing EVO-ONE ALL IN ONE DATA REMOTE START/ALARM WITH T HARNESS AND CRIMESTOPPER REVO4 ANTENNA W REMOTES. I am following the steps on page 3 KEY BYPASS PROGRAMMING PROCEDURE. I am stuck on Step 4. The red light will not flash. I do not have the CAN LOW & CAN HIGH plugged in. I do not have the DATA1 and DATA2 wires plugged in. Do I need those plugged in? I do hae the yellow IGNITION WIRE tapped into the T harness and the KeySens tapped into the white 2 Pin Connector under the steering wheel.