Please help with this matter. I own a Toyota Prius 2009 (JTDKN36U701024344) push to start and bought EVO-ALL (Service #: 001A06 465230) and Flash-Link-2 (Service #: 002502 016969) flashed the last firmware for my car and verifyed 10 times that wire connection are correct. Problem is that this model of Toyota seems to have kind of different ECU connections, as par example Rx is on pin 16 on L7 connector and Tx on pin 4 on the L7 connector. I hooked up the rest of wires accordingly to your schematics (A1 to red wire Ignition on the connector showed in schematics, and CAN high an low on pins 6 & 14 on OBD-II connector along withB4 on pin 16) the A14 wire not hooked up as my L7 connector is differend as I said before (also is white instead of black). Then followed programming procedure but instead of a fast blinking blue led on the x2 start push button I get a fast blinking yellow led. Please advise. A connection diagram for this specific car will be extraordinary.
Thank you for your time!
Best regards,
Lucian
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
