Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

Nissan Rogue 2014 Push to start - Blue light does not flash when start pushed

0 votes
Following the steps. Program button pressed when data plug in. Stop on blue.

Blue stays solid. Plug in rest of plugs.

Press start once (no brake pedal) and all Evo-all module lights turn off. Nothing else happens. This is where the blue LED should flash three times, but it does not.

When I press stop again (after waiting a bit) blue light goes on solid.

Testing remote start (press 3 times) nothing happens. Blue light stays on.No remote start occurs. On a side note, it did flood the Car with gas, as I heard the feul pump run and had to hold hte starter down for almost a minute to clear it.

Bought as part of T-harness kit Evo-NIST3.

Also, Do I need to install Hood switch and valet lock if I have an Evo-all and Fortin T-Harness?"

Service # 001A06859857

Firm v 4.18

Hardware ver 6
Date 10/2018
asked Dec 23, 2018 in Nissan by Tom Tinney (180 points)
edited Dec 26, 2018 by Tom Tinney

1 Answer

0 votes
Your EVOALL must be updated to the minimum version located on page 1 of your install guide.

You will also need the Flashlink updater to do the Dcryptor process.
answered Dec 28, 2018 by Mathieu Bertrand Collin (50,060 points)
...

Wirecolor.com

the ultimate online tool

Visit wirecolor.com for wiring information and photographs providing detailed installation processes.

Email Sign Up

Get products & corporate
updates with our newsletter.