FAQ User

Your Cart

18/01/2018

Mazda matthew irizarry (290Pts.)

blank after keys programmed and car doesn't start after correct installation

Mazda CX-5 2016 auto w/ push to start
Parts Used: Evo-ALL with THAR-Maz1 hardness
Guide Used: 62951
Wires hooked up:
Parking Lights- Yellow/Red, Yellow/Blue, Yellow/Green
Connector A into Connector C and Connector B plugged into Plug 1.
Data Door Lock- Lt. Blue to Green/Orange
Data Key- Lt Blue/Black to Black/White
Yellow- Nothing NO RF KIT USED
White and Black plugs on end of 4-wire Data plug- nothing (NO RF KIT USED)
(-) Lock, (-)Unlock, Start/Stop External- None hooked up, USING OEM KEYS TO START.No Hood Pin installed, Hood Pin Wire connected to Black Wire (PA-pin7-PB-pin11) in Fusebox

After completing step 12 on guide the yellow light turns off and nothing happens. The unit just goes blank. First thing I did was try to find a solution. Then I reflashed the unit with the firmware and tried it all over again. Nothing changed still all same results so I went over all the connections I made and all are firm and good connections. I don't don't get any flashing lights to indicate a fault either.

I have solved all issue, please read my replies. if I can help post or email me at matthew.irizarry.mi@gmail.com I will try to assist you if you have the same car and unit as I do.