Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

2013 ford mustang (manual transmission) remote start does not work.

Vehicle - 2013 FORD Mustang manual transmission. Install - EVO ONE, T-harness, mobile link updater After key bypass programming, the engine does not start even when pressing the 3 x Lock button. But, If you press the lock button 3 times, the EVO ONE module will make a tick-tick and sound 3 times. Is the harness installation wrong?

0

where do i access the REMOTE STARTER options to enable option 38 to mode 2

lblblblblblblblblblblblblbblblbbl

05/01/2022

Ford Gdrover (400Pts.)

0

2013 Ford Fiesta Evo All with THOR-For1 T-harness will not Activate/Respond when remote start attempted using OEM 3Xlock

2013 Ford Fiesta Evo-All with THOR-For1 T-harness will not Activate/Respond when remote start attempted using OEM 3X lock One OEM key Wiring completed per Instalation Guide #58161 Decryptor programed per process outlined starting Page 8 of Guide #58161 for one OEM key When completing steps 1 to 9 all lights correctly match the Guide #58161 with step 9 flashing blue and then to Step 10 alternating Flashing Red to Yellow when key turned off Completed Steps 11 to 13 using Flashlink Dispalys successfully Programed When reconnected to wiring harnesses and perform 3x lock on OEM Key there is no response of any kind from Remote start.. All wiring have been confirmed to be correct per Guide #58161 With ignion key off and key out there are no lights displayed on the Evo-All When engine is running with key the Yellow Evo-All light is dispalyed solid

05/01/2022

Ford Gdrover (400Pts.)

0

2013 Ford Fiesta Evo All with THOR-For1 T-harness will not Activate/Respond when remote start attempted using OEM 3Xlock

2013 Ford Fiesta Evo-All with THOR-For1 T-harness will not Activate/Respond when remote start attempted using OEM 3X lock One OEM key Wiring completed per Instalation Guide #58161 Decryptor programed per process outlined starting Page 8 of Guide #58161 for one OEM key When completing steps 1 to 9 all lights correctly match the Guide #58161 with step 9 flashing blue and then to Step 10 alternating Flashing Red to Yellow when key turned off Completed Steps 11 to 13 using Flashlink Dispalys successfully Programed When reconnected to wiring harnesses and perform 3x lock on OEM Key there is no response of any kind from Remote start.. All wiring have been confirmed to be correct per Guide #58161 With ignion key off and key out there are no lights displayed on the Evo-All When engine is running with key the Yellow Evo-All light is dispalyed solid

0

No key detected message, Ford transit connect

After programmed evo-all fort1 in ford transit connect 2015 all of my original keys stopped working and I have a message "No key detected". Programming procedure went exactly the same as in the guide. Car doesn't start with the 3xlock also. any Idea what is the problem ?

0

2016 Escape, remote starts by pushing lock/unlock door switches and park light prob.

Installed EVO-ALL with T-harness 4 on my 2016 Ford Escape. Everything works ok except these 2 issues. 1. I programmed to start with the lock-unlock-lock command using factory fob. It works with the fob but it will also start by pushing interior door locking switches in the same manor. Is this normal? I did connect the white to unlock and white/black to lock through a diode per instructions. I also cut the door pin wire and connected the green/white to the low volt side and green/red to the high volt side per instructions. Not sure if any of this plays a part but it doesn't seem to me it should work this way. 2. I installed the parking light relay per instructions. I thought the relay would allow the park lights to come on while the vehicle is running on remote stater. I does not. The relay trigger is connected to the brown/white wire. I have tested the relay by grounding the trigger wire and it does turn on park lights, just doesn't turn them on during remote start run time. I did turn on parking light control option in the program. Any suggestions appreciated.

0

2014 Transit Connect No Key

I have a different problem than the other NO KEY DETECTED questions in the forum. 1. I have a flash updater ( most current flash) 2. I checked all the wiring and voltages 3. Using the Fort1 on 2014 Transit Connect XL with no existing remote start After programming with the 2 key method, the read out says NO KEY DETECTED and the car does not start, but the car goes into run mode. After reinsterting the key, the car still will not start with the key, until the EVO is unplugged. After programming with the Dcrytor method, the Fortin Updater says there is no key data.

0

2014 F150 Evo-One with t harness dose it support 3x remote start without additional units ?

I have evo-one want to installe it on 2014 ford f150 dose it soppurt 3* remort start?

0

2015 Transit Evo-One with t harness 3x remote start won’t work after programming

Went through programming. Red light is on next to loop and loop was cut before install. No color lights come on when remote starting. Hooked up to guide 72581. Did not hook up door locks, parking lights and or hood pin yet. Does good pin need installed to make work?

0

Car will not stay running when reservation mode is set

2011 mustang gt, option for manual transmission is selected. When performing reservation mode the relay clicks 3 times and flashes blue then red. When key is turned off the car shuts down and does not remain running. Seems to be the bypass is not working I tried both options. Two key programming and the decryptor option. Does anyone have any ideas why this would be? Using thar-for4 harness. Harness A door immobilizer is being used not b as the manual suggests

0

2018 Ford F-150 STD key evoall not starting truck

Plugged in the Tharness correctly. When connecting the moduel I held down the small button on it while connecting the black power wire, and let go of it when the light was blue. Connected the white wire on the other side of the module. turned on truck to ignition on, waited for blue light to flicker for a bit then ignition off and key out. Tried the triple press on lock and nothing happens. Turn to ignition on again and the module is showing a yellow light.

Cant get the remote start to work

 

SN:001A07005461 Model:EVO-ALL

 

0

2018 Ford F150 Std Key Fort3 isnt remote starting car

Plugged in the Tharness correctly. When connecting the moduel I held down the small button on it while connecting the black power wire, and let go of it when the light was blue. Connected the white wire on the other side of the module. turned on truck to ignition on, waited for blue light to flicker for a bit then ignition off and key out. Tried the triple press on lock and nothing happens. Turn to ignition on again and the module is showing a yellow light. Cant get the remote start to work

0

2018 F250 flip key remote start not starting if truck sits for a couple days

I used EVO-FORT1 (Evo-all with Ford t harness) 3x lock. I installed on 2018 F350 tow trucks. Most have air brakes. If the truck sits for a couple days and you try to remote start, It says "brake error" on the dash and will not start. If you start it with the key, let it run for a while and then remote start it works fine. let it set a few days "brake error" and no start. Any idea how to fix this? I did a fleet of 15 trucks and 12 have air brakes and all 12 with air brakes are doing this. Customer is not happy. Please help asap.

1

15 Ford Fusion standard Key will run only for 10 mins no matter what I set it to.

2015 Ford Fusion Automatic Standard Key Stand alone I have Evo All hardware ver 6 software 4.01 It will run only 10 mins even if I will set it to 30 in diesel mode. I updated the software to 4.02 like recomended by the flashlink but than my car will not start at all so I went back to 4.01 and same 10 mins at 15 set. Please advise.

1

15 Ford Fusion standard Key will run only for 10 mins no matter what I set it to.

2015 Ford Fusion Automatic Standard Key Stand alone I have Evo All hardware ver 6 software 4.01 It will run only 10 mins even if I will set it to 30 in diesel mode. I updated the software to 4.02 like recomended by the flashlink but than my car will not start at all so I went back to 4.01 and same 10 mins at 15 set. Please advise.

0

CRIMESTOPPER RFALL642W Is not allowing key fobs to program.

The 2 way fob setup is following the setup through the step where the Evo-all module is red yellow and blue while the key is turned to the on position. The antenna is supposed to be flashing rapidly but instead flashes intermittently and sporadic. The fobs are programmed by pressing the “-“ then the lock button, the “-“ button shows the green light flashing then when the lock button is pressed it flashes blue thena red light with a single tone. 

 

Options I have selected 2008 Ford Escape hybrid. 

A1-11


C1

D1 D1.7 D4

G

G1 G2

H2

0

Evo One w/T-Harness installed on 2014 Ford Mustang

Hello, I purchased an Evo One with T-Harness for my fiance's 2014 Ford Mustang with automatic transmission. We took it to a recommended installer. After they installed it, they informed us that the 3x lock remote start did not work. They blamed it on the key and said the key was an after market key and does not synch with the Evo-One system. There is no response from the Mustang - flashing brake lights or sounds - when you attempt a 3x lock. We took it to another installer and after looking at it - they said the whole Evo One system would need to be taken out and sent back to Fortin to have it flashed. Based on these two responses, I believe these installers are not familiar with the Evo products and simply want to lead folks to purchase their products which they are familiar with. Typically, I have done a lot of my own work to my cars for years. However, since this was my fiance's car and it is winter - I figured it was best to take it to an installer. Now - I'm digging through your guides and learning about your products - I have some questions. 1. Any immediate thoughts to the installer comments? 2. My fiance only has 1 key for her Mustang. In your procedures, do you require 2 keys for programming? Or - can the system be programmed with one key? 3. In the packaging that was returned to us after the 1st installer, I noticed that the hood pin was still in the box. Is the hood pin absolutely required for the system to operate correctly? 4. Can the system be programed without the Flash Link Updater? Per your installation guides, it seems that the system can be programmed either by using the OEM keys - or - with the Flash Link Updater/Dycryptor Technology. Your feedback is greatly appreciated. Thank you!

0

I have a 2011 Ford Taurus fort1 once I hit the lock 3xs the car starts And shuts off

The vehicle starts and shuts off two times then it won’t attempt to start until the lock button is pressed 3 times again and it repeats itself again, I’m getting 3 flashing red light after vehicle shuts off on the second attempt which states no tach signal so I’m stuck here what do I do to make the car stay running I used two keys for programming and verified all connections the car runs for about 5 seconds then shuts down each time it starts up.

0

How long will the car run for after remote start before a key is put in?

Dear All, I have recently installed the Evo fort1 with Tharness stand alone into my Ford Explorer 2015 (standard key). it works quite well. I have noticed though that it seems after a while the car shuts down. iw as wondering is this a configurable option or that is the way the module is designed?

0

Vehicle doesnt shut off unless the lock 3x is used or timer runs out. 07 ford edge

I followed the install instructions and programmed with two keys, and the it'll start, but I either have to way until the timer runs down or hit lock 3x. 2007 ford edge with evo all standalone.

0

Vehicle doesnt shut off unless the lock 3x is used or timer runs out. 07 ford edge

I followed the install instructions and programmed with two keys, and the it'll start, but I either have to way until the timer runs down or hit lock 3x. 2007 ford edge with evo all standalone.

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue